Dwyer 8B User Manual
Page 22
Page 22
System Alarm Setting. Selects which of the alarm outputs is
used if a system alarm occurs. The system alarms would be
an input error or a process control failure. This feature can be
disabled by turning this parameter to oFF.
Communications Write Function Feature. Allows parameters
to be changed via the RS-485 communications. Setting to oFF
prevents any changes from remote users.
Protocol Selection: Select whether to communicate using ASCII or
RTU Protocol. This value must match the protocol used by the host
computer.
Controller Address: Set from 1 to 247. This value must match
the controller address used by the host computer.
Communication Data Length. Choose either 7 or 8. This value
must match the communication data length of the host computer.
Communication Parity Bit. Set this value to even, odd, or none.
This value must match the communication parity bit of the host
computer.
Communication Stop Bit. Set this value to 1 or 2. This value
must match the communication stop bit of the host computer.
SALA
CoSH
C-SL
C-no
LEn
PrtY
StoP