Badger Meter M-Series M3000 - Manual (Page 29)

29
9. Press + to set at Exit WITH save.
10. Press E to Save.
11. After pressing E, the menu goes back to ANALOG
OUTPUT 31. Press + three times to place arrow at FS
Calibrate. Press E once.
12. Screen ANALOG FS CAL 3C comes up. Press + to set
the arrow across from Decrease AO or Increase AO.
Press E button until amp meter reads the desired Full
Scale Set-point.
13. Press + to set screen at Exit WITH save.
14. Press E to Save.
15. ANALOG OUTPUT 31 returns with the arrow pointing at
Exit this Menu. Press E.
16. IN/OUTPUTS 30 returns with the arrow pointing at Exit
this Menu. Press E.
17. MAIN MENU 00 returns with the arrow pointing at Exit
this Menu. Press E.
18. The screen returns to the Main Screen.
The above programming sequence guided you through
various screens and programming. These are the basic
features that need to be programmed initially. Please refer to
the programming fl ow chart located on pages 35-37 for all of
the programming options.