Badger Meter M-Series M3000 - Manual (Page 22)

22
8. The screen automatically returns to METER SETUP 10
with the arrow pointed at Exit this Menu.
Transitions
1. Press + or – to position the arrow at another selection or
E to return to the Main Menu.
2. Use the E key to return to screen Main Menu 00.
3. Next, press + three times to position arrow at Inputs/
Outputs.
4. Press E.
5. Press + three times to position arrow at Digital Out. #1 on
screen In/Outputs 30.
6. Press E.
7. Press + once to move the arrow across from Pulses / unit.
8. Press or activate E.
Pulses / Unit 3D is a typical Input Numbers screen.
1. When the screen opens, the arrow is pointing at a
number.
2. Use + or – selections to increase or decrease the
underscored number to the desired digit.
3. Select E to move the underscore to the next digit and
repeat the number selection process.
4. To skip a digit press E. The underscore moves to the next
digit.
5. When all digits are set, press E. Pulses / Unit 3D is
programmed into the system and the screen Dig Output 1
33 returns.
Empty Pipe is a “branch” list screen from the MAIN MENU.
From here calibrate ON or OFF is made.
1. Press E to activate the Main Menu 00 screen.
2. Press the + once to place the cursor at Meter Setup.
3. Press E to bring up Meter Setup 10 screen.