Badger Meter M-Series M5000 - Manual (Page 16)

CONFIGURING INPUT/OUTPUT (I/O)
This section describes wiring the following M5000 outputs:
• Digital outputs
• Communication
When the sensor and the amplifier have been wired, wire any outputs to the M5000 amplifier .
Follow all of the safety precautions and local code to prevent electrical shock and damage to the electronic components .
Circuit Board Diagram
Figure 21: Configuring Input/Output
Input/Output Description Terminal
Output 1 Passive max . 30V DC, 20 mA
Max . Frequency 100 Hz
OUT1 (+) and (–)
Output 2 Passive max . 30V DC, 20 mA
Max . Frequency 100 Hz
OUT2 (+) and (–)
Output 3 Passive Max 30V DC, 20 mA OUT3 (+) and (–)
Output 4 Passive Max 30V DC, 20 mA
Can be used with digital input as an ADE interface .
OUT4 (+) and (–)
RS232 Modbus RTU RxD, TxD, GND
IN Digital input 3…35V DC IN (+) and (–)
M-BUS M-Bus interface No polarity
Configuring input/output (i/o)
MAG-UM-00219-EN-03 Page 16 August 2014