Alicat Flow Vision SC - Manual (Page 32)

32
Sample Script
Below is a sample script that will cause a flow controller to:
1. Change the set-point to 0 at .1 seconds from start (controllers only)
2. Tare at .3 seconds from start
3. Reset the flow totalizer at .5 seconds from start (devices with totalizer
only)
4. Change the set-point to 25% at 1 seconds from start (controllers only)
5. Change the set-point to 10SLPM at 2 seconds from start (controllers
only)
6. Change the set-point to 15SLPM at 3 seconds from start (controllers
only)
7. Change the set-point to 100% at 4 seconds from start (controllers only)
Once you have completed a script, you can review your selections. If you
decide you don’t want particular steps, they can be removed by selecting the
specific step(s) and then clicking the “Remove Selected” button.
Finally, click the “Save” button to save the script into the Script module tab.