Alicat Flow Vision SC - Manual (Page 31)

31
Descriptions of Simple Script Commands
Write Address
The Write Address command allows you to write a value to a register address
of the instrument. You are required to enter Execution Time, Address Code
and Address Value. The Address Code is the actual address to be changed,
while the Address Value is the value for the register.
Please note: Written register values are not easily undone. You must rewrite
the original value to the register if you want to undo your changes.
Please use this function only if you are sure you need to do so and only
after recording the original register value. If you are unfamiliar with register
values and their corresponding functions, please contact Alicat or your local
distributor for information.
Change Set-point (Scale Units)
The Change Set-point (Scale Units) command lets you change the set-point
of the instrument as a function of the unit’s scale. Selecting this command will
cause an Input window to appear that requires input of Execution Time (in
seconds) and Scale Units.
Please note: The Change Set-point (Scale Units) function is only available
with controllers.
Change Set-point (% of Full Scale)
The Change Set-point (% of Full Scale) command allows you to change the
set-point of the instrument as a function of percentage (0 - 100%). Selecting
this command will cause an Input window to appear that requires input of
Execution Time (in seconds) and % of Full Scale. It is not necessary to use the
“%” symbol when populating the Parameter Value.
Please note: The Change Set-point (% of Full Scale) function is only available
with controllers.
Tare
The tare function is used to set the zero on the instrument. Tare only when
there is no gas flow going to the unit. The tare function is discussed in detail in
the instruction manual that accompanied your instrument. Choosing the tare
function will cause an Input window to appear that requires input of Execution
Time (in seconds).
Reset Total
The Reset Total function is used to reset the instrument’s flow totalizer.
Choosing the Reset Total function will cause an Input window to appear that
will require input of Execution Time.
Please note: The Reset Total function is available only for instruments ordered
with the optional totalizer.