Alicat Flow Vision SC - Manual (Page 30)

30
Scripts
Scripts allow users to create automated command sets based on time. You
can program Flow Vision™ SC to send specific commands to your connected
flow instruments at specified time intervals.
To create a script, you will first need to access the Script module tab. If you do
not see the Script module refer to section 2 (page 11) for instruction on how to
make the Script module visible.
Once you have accessed the Script module, click “Add” to bring up the New
Script window.
At the top of the window, in the box to the right of “Script Name”, name the
script you are building. You can name the script anything you would like.
To the left of the device for which you would like to add a command, press the
“+” symbol to display a list of available commands.
Add a command by either double-clicking on the desired command or clicking
and dragging the command into the box on the right half of the screen.
After you have double-clicked or dragged a command, an Input window will
appear in which you will fill in the blanks with your desired values.
Note: The common value among all the script functions is Execution Time.
The Execution Time is the time (in seconds) at which the address change
should take place from the start of the script.
Once you have populated the Parameter Values, simply click the “Add
Command” button to add the command to the script.
If you require the script to run in a loop, you can select the number of loops to
run and the time between each loop in the Options tab.