4 filter 24, 5 substitue value for inputs 24, 6 input forcing 24 – West Control Solutions SG 45 User Manual

Page 24: Filter 24, Forcing of the inputs 24, Substitute value for inputs 24

6.2

Input scaling

Scaling of input values is possible. This correction influences the measured value after an eventually executed
linearization.

Specification of the input value of the lower and upper scaling point is in units of the relevant physical
quantity.

The Parameters

InL, OuL, InH and OuH are always visible. These are created during calibration.

Parameters

InL and InH determine the input range.

Example with %:
InL= 4 and InH = 10 means that measuring from 4 to 10 % is required.

For resetting the input scaling, the settings for

InL and OuL as well as InH and OuH must

correspond.

Functions

SG 45

Input scaling

mA/V

phys.

quantity

mA / V

phys. quantity

OuH.x

OuL.x

InH.x

InL.x

Example for %