Techne TC-PLUS - Manual (Page 57)

55
CURRENT STATUS
The Current Status area of the Home Screen provides status information on the TC-PLUS and any
connected Satellite units.
On the Home Screen, the Current status area shows
the versions of software and firmware loaded on the
unit.
• Touch the Current status button to view the status
of the TC-PLUS and any connected units.
The TC-PLUS and any satellite units connected to it
will be listed. The ID shows the serial number of the
unit in brackets and for Satellite units the ID number
allocated in square brackets.
If a unit is running a program, as shown by the status,
the Run Screen can be viewed. Runs can then be
paused or stopped as required.
• Touch the area to select the required unit.
• Touch View.
• Touch Cancel to return to the Home Screen.
Reset Satellite IDs
When first connected, a Satellite unit is allocated an ID
number by the TC-PLUS. The ID numbers can be
reset following the instructions given below.
• Remove the USB cables from the rear of the
Satellite units.
• Touch Reset All Satellite IDs.
• During the next 60 seconds, re-insert the USB
cables in the order you wish the Satellite IDs to
occur (0 to 8).
• When done, touch OK.