Techne TC-PLUS - Manual (Page 29)

27
• Touch Cancel to return to the previous screen if no
changes are required.
Advanced time entry
• First ensure the number of cycles for the stage has been set then enter the required hold time as
described above.
Note: Increase/Decrease Per Cycle will be inactive unless the number of cycles set is greater than 1.
To increase the step hold time per cycle:
• For an increase in hold time per cycle, touch the
button below Increase Per Cycle to turn this
function on. Next touch the time entry button below
this.
A new screen will open which is similar to the simple
time entry screen. The maximum increase in hold
time per cycle (based on the number of cycles and
the time limits of the unit) will be shown.
• Enter the required value using the + and - buttons.
• If an entered incremented time is invalid, a prompt
will indicate the acceptable range.
• Touch OK to return to the previous screen.
The increase in hold time per cycle will now be
displayed.
• Touch OK again to return to the programming
screen.
• Touch Cancel to return to the programming screen
if no changes are required.