Techne TC-PLUS - Manual (Page 46)

44
SETTINGS
• Touch the Settings button to view the instrument
defaults as set up in the instrument Settings
module.
Any of these parameters can be edited by touching the
appropriate button and will be saved for the current
program only.
• Touch Program to return to the programming
screen.
VIEW
• Touch View to see a graphical representation of the
program.
• If the program has more stages and steps that are
displayed on the screen, scroll through the program
by dragging a finger across the touch screen.
The centre of the screen shows each temperature step
and hold time (not to scale). Stages are indicated by a
white bar spanning the steps within the stage.
The bottom of the screen shows the name of the
program and the expected end time if it was started
immediately.
Note: The program is not saved at this point.
• Touch Start to start the program.
Note: It is not possible to send the program to
connected Satellite units from a view screen.
• Touch Edit to edit the program.
• Touch Back to return to the Programming Screen.
Note: The temperature log will remain blank until the
program has been started.
If a step has a gradient programmed into it, the bar will
be shown thicker and indicate the upper and lower
temperatures of the gradient range.
If a step has an incremented or decremented
temperature, this will be indicated by a white spot next
to the temperature.
If a step has an incremented or decremented time, this
will be indicated by a white spot next to the time.
Gradient Inc/dec
temperature
Inc/dec time Gradient Inc/dec
temperature
Inc/dec time