Spectrex 40/40U-UB - UV Flame Detector - Manual (Page 56)

SharpEye TM UV Flame Detector User Guide
44 Outputs
A.2 Electrical Specifications
Operating Voltage:18-32 VDC
Power Consumption: Table 19
Table 19: Electrical Specifications
Operating
Voltage Status All
Outputs Without
0-20mA
Power
Consumption
(Max. 24VDC)
Normal 1.61W 1.56W
Normal when Heater On 2.28W 2.16W
Alarm 2.64W 2.28W
Alarm when Heater On 3.24W 2.88W
Maximum Current
(Max. 24VDC) Normal 70mA 65mA
Normal when Heater On 95mA 90mA
Alarm 110mA 95mA
Alarm when Heater On 135mA 120mA
Power
Consumption
(Max. 18-32VDC)
Normal 1.95W 1.85W
Normal when Heater On 2.56W 2.45W
Alarm 3.04W 2.56W
Alarm when Heater On 3.68W 3.2W
Maximum Current
(18-32VDC) Normal 90mA 85mA
Normal when Heater On 105mA 100mA
Alarm 130mA 115mA
Alarm when Heater On 160mA 145mA
Electrical Input Protection The input circuit is protected against
voltage-reversed polarity, voltage transients,
surges and spikes according to MIL-STD-
1275B
A.3 Outputs
Electrical
Interface There are five output-wiring options. These options must
be defined at the factory per the customer order and
cannot be changed at the customer facility.
See General Instructions for Electrical Wiring on page 49
for the wiring/terminal diagram for each option.
Unless otherwise specified, the default is Option 1. The
wiring arrangement is identified on the detector by the
part number (see Model and Types on page 2).
 Option 1: Power, RS-485, 0-20mA (Sink), Fault I
Relay (N.C), Alarm Relay, (N.O) (see Figure 7).