KYORITSU 5000 Instruction Manual - Manual (Page 39)

― 37 ―
9. Battery replacement
WARNING
¡ In order to avoid electrical shock, remove sensors from the
instrument when replacing batteries.
CAUTION
¡ Do not mix new and old batteries.
¡ Install batteries in the orientation as shown inside the battery
compartment, observing correct polarity.
When only the leftmost segment of the Battery mark is flashing on the
LCD
, it means battery voltage is low. Replace the batteries with
new ones. There is no influence on the measurement accuracy even if
this warning mark is flashing. Nothing even the Battery mark
is
displayed on the LCD if the batteries are completely exhausted.
Replace the batteries with new ones.
(1) Loosen two Battery-cover
-fixing screws on the
backside of the instrument
and remove the cover.
(2) Replace the batteries with
new ones.
(Battery : Alkaline, LR6,
1.5V)
(3) Install the Battery cover, and
tighten up the screws.