KYORITSU 4106 - Manual (Page 21)

17
Selecting a desirable frequency with the Cursor Key, and pressing the
“ “ Key returns to the “CONFIG_SETTING” Screen (Fig.12) with the
selected frequency.
8-2-4 Site (location) No. Setting
The site (location) where measurements done can be saved with numbers.
Select “Site” with the Cursor Key on the CONFIG_SETTING Screen, and
press the “
” Key to display the Site_Number Setting Screen (Fig.13).
Select any digit to be changed with the Cursor Key, and press the “ ”
Key. Then the selected digit is highlighted and ready to be changed. (Fig.14)
Press the Right Cursor Key to increase numbers and the Left Cursor
Key to reduce numbers. Keep the Cursor Key pressed down to change
numbers quickly. Press the “ ” Key to confirm a number.
Repeat this procedure to change the other digits. Press the “ ” Key
when settings are done. Then the CONFIG_SETTING Screen (Fig.15) with
the selected Site No. will be displayed.
Note) Site No. is selectable from 000 to 999.
Fig. 12
Fig. 13
Fig. 14
Fig. 15