Installation, Meter case, Models prepped for card reader – Alliance Laundry Systems W446I User Manual

Page 9

38857

Installation

Meter Case

The factory mounted coin meter case does not include

the service door lock, slide, coin drawer, coin drawer

lock or keys. These parts must be ordered (at extra

cost) according the purchaser’s requirements direct

from the manufacturer of your choice.

NOTE: You have the option of using a screw type
lock or a 1/4 turn lock on the meter case service
door. If you choose to use a screw lock, then the
special bracket (located inside the meter case) must
be used. DO NOT use the special bracket if a
1/4 turn lock is used.

Coin Drawer Security

– For additional security, drill

out the two pilot holes on each side of the front of the

meter case to 1/4 or 5/16 inch (6.4 or 7.9 mm) holes

and install a bicycle lock through these holes.

NOTE: An 8 in. (20.32 cm) coin drawer is required
for coin operated electronic control models.

Models Prepped for Card Reader

The machine is shipped from the factory with the

Electronic Control Diagnostic Harness Assembly

unplugged. To avoid unauthorized manual

programming or vending, perform the following steps.

1. Open service door. Refer to Figure 1.
2. Locate diagnostic harness on electronic control.
3. Plug connectors for “white/black” wire and “red/

blue” wire together.

Figure 1

FLW6R

Service Door