Alliance Laundry Systems W446I - Manual (Page 11)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Installation
9 38857
Before You Start
Tools
For most installations, the basic tools you will need
are:
Figure 2
Electrical
Washer needs a 120 Volt, 60 Hertz, polarized three slot
effectively grounded receptacle. For more detailed
information, refer to section on Electrical
Requirements
.
Water
Washer needs two standard 3/4 inch (19.05 mm) water
supply faucets with a pressure between 20 and 120
pounds per square inch. For more detailed information
refer to section on Water Supply Requirements.
Installing the Washer
NOTE: If the washer is delivered on a cold day
(below freezing), or is stored in an unheated room
or area during the cold months, do not attempt to
operate it until the washer has had a chance to
warm up.
Step 1: Remove the Shipping Brace and
Shipping Plug
IMPORTANT: Install dryer before washer. This
allows room for attaching exhaust duct.
Remove the shipping brace from under the lid. The
plastic shipping plug will be released from the base of
the washer when removing the cardboard base from
the washer.
The shipping brace and plug should be saved and must
be reinstalled whenever washer is moved or
transported to a new location. This will prevent
damage to washer components.
Do not tilt washer to front or sides when moving.
Refer to User-Maintenance section for instructions on
reinstalling shipping brace and shipping plug.
Figure 3
D074I
1 Wrench
2 Screwdriver
3 Pliers
4 Level
D074I
1
2
4
3
TLW520N
1 Shipping Brace
2 Shipping Plug
TLW520N
1
2