Alliance Laundry Systems W446I User Manual

Page 15

Installation

38857

Step 6: Plug In the Washer

Refer to the following section on Electrical
Requirements

before plugging in the washer.

Figure 10

Step 7: Add Water to the Washer

To prevent damage to pump, do not run washer before

adding at least one quart water to the tub. If the washer

is run before any water is added, the pump seal may

overheat, causing the pump to leak. Once installed, the

water retained in the drain system from the previous

cycle will provide sufficient cooling to prevent pump

seal damage.

NOTE: The agitator should not be removed except
for service. The washtub is designed to be self-
cleaning.

Figure 11

Step 8: Check Lid Switch

Washer should stop filling, agitating and spinning

when lid is opened.

Figure 12

Step 9: Check Installation

Refer to Installer Checklist on the back cover of this

manual and make sure that washer is installed

correctly.

D254I

TLW524N

D254I

TLW1974N