KROHNE BM 102 EN - Manual (Page 19)

BM 102 19
3 User interface
3.1 Power-on and start-up
The BM 102 is pre-configured in accordance to customer order specifications and measurements
can be made immediately. A warm-up time of less than 23 seconds should be allowed for once
connected and the power is switched on.
3.2 Available user interfaces
Measurements may be taken using either:
• PC STAR 2 software
Included as standard with the instrument. The
basic installation & operating instructions are
presented in section 3.3.1 (requires PC
workstation).
• HART ® Handheld Communicator (HHC) Sold separately. Automatic recognition of the
instrument when connected. A list of HHC-
accessible parameters is given in the BM 102
Handbook.
• DA 06 local indicator Sold as an option for devices equipped with DIN
connectors. For displaying readings only. Refer to
section 3.3.3 for technical data.
3.3 Operator control and display
You can configure the device by way of the PC-STAR 2 software or the HHC. Refer to the BM 102
Handbook, section 3.3 for more details. This document is available from your local KROHNE Sales
office or in the “Download Centre” on KROHNE’s website http://www.krohne.com/.
3.3.1 PCSTAR 2 Version 2.01 for Windows : basic installation & operating instructions
Software description
PC STAR 2 is a Windows program that permits clear and concise display of data and configuration
of the BM 102 from a remote location. The program is available in English, German or French.
PC-STAR 2 system requirements
• PC with at least 486 processor 75 MHz, recommended: Pentium 120 MHz or higher
• Microsoft Windows 9x, Me, 2000, NT and XP
• Min. 16 MB main memory (RAM)
• Min. 3 MB available hard disk storage
• 3 ½ “ Floppy disk drive
• Mouse or other pointing device
• Serial RS232 port