KROHNE OPTISENS AAS 2000 EN - Manual (Page 21)

ELECTRICAL CONNECTIONS
4
21
OPTISENS AAS 2000
www.krohne.com 12/2008 • MA AAS 2000 R01 en
Electrical connections
4.1 Safety instructions
4.2 Cable connections
Connect the sensor to the MAC 080 converter using the connector on the end of the attached
sensor cable. In the event that two sensors are to be connected to the same converter, use the
optional junction box.
DANGER!
All work on the electrical connections may only be carried out with the power disconnected. Take
note of the voltage data on the nameplate!
DANGER!
Observe the national regulations for electrical installations!
WARNING!
Observe without fail the local occupational health and safety regulations. Any work done on the
electrical components of the measuring device may only be carried out by properly trained
specialists.
INFORMATION!
Look at the device nameplate to ensure that the device is delivered according to your order.
Check for the correct supply voltage printed on the nameplate.
INFORMATION!
Please refer to the MAC 080 manual for detailed information.
.book Page 21 Monday, December 15, 2008 12:43 PM