AT&T DEFINITY 7200 series User Manual
Page 270

C-30
TRUNKING TERMS AND CAPABILITIES
_
___________________________________________________________________________________________________________________________
_
___________________________________________________________________________________________________________________________
_
___________________________________________________________________________________________________________________________
_ ______________________________________________________________________________________
SWITCH A
FOR EACH "SWITCH A" TRUNKING OPTION (LISTED BELOW) — REFER TO THE
CORRESPONDING RECOMMENDED "SWITCH B" TRUNK OPTIONS (RIGHT FACING PAGE).
_ ______________________________________________________________________________________
GROUP/CALL TYPE DIREC-
SUPERVISION
SIGNALING
_ ____________________
TION
_ ________________________________________________________
GENERIC 2,
GS LS RB E&M ISDN
INCOMING
OUTGOING TIMEOUT
SYSTEM 85, OR
DIMENSION PBX
"ALERTING" "ADDRESSING" (NOTE
3)
_
______________________________________________________________________________________
_
______________________________________________________________________________________
101/DATA 2W
27 IMMED-START
IMMED-START
ANALOG DATA
MODEM SIDE
_ ______________________________________________________________________________________
_ ______________________________________________________________________________________
102/DATA 2W
18
DCP S-CHANNEL
DCP S-CHANNEL
(Note 16)
DIGITAL DATA
DATA MODULE SIDE
_ ______________________________________________________________________________________
_ ______________________________________________________________________________________
103/HOST ACCESS
2W
18
DCP S-CHANNEL
DCP S-CHANNEL
(Note 16)
LINE SIDE
_ ______________________________________________________________________________________
_ ______________________________________________________________________________________
104/HOST ACCESS
2W
18
DCP S-CHANNEL
DCP S-CHANNEL
(Note 16)
TRUNK SIDE
_ ______________________________________________________________________________________
_ ______________________________________________________________________________________
105/3B5 2W
18
DCP S-CHANNEL
DCP S-CHANNEL
(Note 16)
_ ______________________________________________________________________________________
_ ______________________________________________________________________________________
106/EIA 2W
18
DCP S-CHANNEL
DCP S-CHANNEL
(Note 16)
_ ______________________________________________________________________________________
_ ______________________________________________________________________________________
107/ISN/EIA 2W
18
DCP S-CHANNEL
DCP S-CHANNEL
(Note 16)
_ ______________________________________________________________________________________
_ ______________________________________________________________________________________
108/DMI 2W
D-5 WINK-START
IMMED-START
_
________________________________________________________
20 DMI-MOS
DMI-MOS (Note
5)
_
______________________________________________________________________________________
_
______________________________________________________________________________________
109/DMI 2W
D-11 WINK-START
WINK-START
OR
(Note
13)
DELAY-DIAL
_
________________________________________________________
20 DMI-MOS
DMI-MOS (Note
4)
_
______________________________________________________________________________________
_
______________________________________________________________________________________
120/ISDN DYNAMIC
2W
20
(Note 17)
(Note 17)
_ ______________________________________________________________________________________
Notes:
16. Requires signaling type 18.
17. The type of signaling being used depends upon the particular trunk type and service being provided for a particular call. Each
call and each channel may require a different signaling method than the previous call, depending upon the different types of calls
and call volume.