beautypg.com

AT&T DEFINITY 7200 series User Manual

Page 258

background image

C-18

TRUNKING TERMS AND CAPABILITIES

_

___________________________________________________________________________________________________________________________

_

___________________________________________________________________________________________________________________________

_

___________________________________________________________________________________________________________________________

_ ______________________________________________________________________________________

SWITCH A

FOR EACH "SWITCH A" TRUNKING OPTION (LISTED BELOW) — REFER TO THE

CORRESPONDING RECOMMENDED "SWITCH B" TRUNK OPTIONS (RIGHT FACING PAGE).

_ ______________________________________________________________________________________

GROUP/CALL TYPE DIREC-

SUPERVISION

SIGNALING

_ ____________________

TION

_ ________________________________________________________

GENERIC 2,

GS LS RB E&M ISDN INCOMING

OUTGOING

TIMEOUT

SYSTEM 85, OR

DIMENSION PBX

"ALERTING" "ADDRESSING" (NOTE

3)

_

______________________________________________________________________________________

_

______________________________________________________________________________________

12/APLT 2W

D-9 DELAY-DIAL

DIAL-TONE

WITH

4-6

SEC

(Notes 1&2)

WINK-START OR

DELAY-DIAL

_ ______________________________________________________________________________________

_ ______________________________________________________________________________________

13/APLT 2W

D-10 WINK-START

DIAL-TONE

WITH

4-6

SEC

(Note 1)

WINK-START OR

DELAY-DIAL

_ ______________________________________________________________________________________

_ ______________________________________________________________________________________

14/APLT 2W

D-8 DELAY-DIAL

DIAL-TONE

WITH

IMMED-START

_

______________________________________________________________________________________

_

______________________________________________________________________________________

15/APLT 2W

D-5 WINK-START

DIAL-TONE

WITH

IMMED-START

_

______________________________________________________________________________________

_

______________________________________________________________________________________

16/CO IN

D-1

_

________________________________________________________

19

_

________________________________________________________

28 AUTO

_

________________________________________________________

29 AUTO

(NOTE

4)

_

________________________________________________________

20 DMI-MOS

(NOTE

5)

_

______________________________________________________________________________________

_

______________________________________________________________________________________

17/CO OUT

D-1

_

________________________________________________________

19

_

________________________________________________________

28 IMMED-START

_

________________________________________________________

29 WINK-START

_

________________________________________________________

20 DMI-MOS

(NOTE

5)

_

______________________________________________________________________________________





Notes:

1. This trunk type is only applicable for APLT through dial applications (EPSCS applications).

2. Connections to an ETN-Main that is not equipped with FP8 issue 3 (yet providing Speed-Calling) should use APLT type-12

trunks (2-way delay /delay). Incoming calls can only reach the attendant via the network LDN(s) e.g., PBX access code plus a
2-, 3-, 4-, or 5-digit number. The single digit "0" will not work.

3. This type of trunk time-out indicates that if no signal is received and its expiration digits are automatically sent for outgoing type

calls, and the trunk is automatically connected for incoming calls. If no signal is received and time-out occurs, then digits are
automatically sent (for outgoing calls), or the trunk is automatically connected (for incoming calls).

4. This trunk type and optional signaling arrangement may be used to build a "Special Access" trunk group. Special Access refers

to a direct connection to a 4 ESS toll switch. A typical application for this trunk type/signaling arrangement is to support
MEGACOM800 DNIS.