Stabilization time – In-Situ Level TROLL 300/500/700/BaroTROLL Operators Manual User Manual
Page 39

1-800-446-7488
39
www.in-situ.com
Stabilization Time
After you have installed the instrument, allow it to stabilize to the environment for about
10 minutes before logging data. The T95 response time for temperature is less than 9
minutes.
A generous stabilization time is always desirable, especially in long-term deployments.
Even though the cable is shielded, temperature stabilization, stretching, and relaxing
can cause changes to readings.
If you intend to monitor water levels to the instrument's stringent
accuracy specifications, allow up to 60 minutes for the probe and
cable to stabilize to the environment.
This manual is related to the following products: