HT instruments SIRIUS87 - Manual (Page 64)

SIRIUS 87
EN - 62
5.3. CLEAR MEMORY
If you want to cancel the stored tests results proceed as follows:
1. Press
the RCL/ESC key. The instrument displays a screen like the
following:
MEM

3
Pla 02
2.
Use the
U
L
▼, S▲keys to select the number of the memory location.
ATTENTION: the instrument will cancel all the results stored from the memory location
selected to the last one full.
3. Press
the DISP key to display the test result related to the memory
location selected. In case that a few results were stored in the memory
location (Ex: RCD test under AUTO mode) it is necessary to press DISP
more than once to display them
4.
Press CLR once. The blinking symbol " clr"
is displayed. Now you face
two possibilities:
MEM

C
i
02 08
Press
CLR again if the tests selected are to be cancelled
starting from the one selected down to the last one saved.
Press RCL/ESC to nullify the clearing phase. The blinking
symbol "clr" disappears.
Press
RCL/ESC key at any time to leave the memory menu and go back
to the measurement selected.
Number of the memory location in which the
measurement results were stored.
Value of the parameter PLA related to the
saved measurement.
DISP
Last location with data stored number.
The instrument cancels the memory cells from
n.2 to n.8, where n.2 is the one selected by
the operator while n.8 is the last test saved in
the instrument.
RCL
ESC
S▲
U
L
▼
CLR
CLR
RCL
ESC
RCL
ESC