GW Instek GDM-8200A DMM-Viewer (PC Software) Guide - Manual (Page 18)

GDM-8200A Series Remote Viewer Guide
18
Configuring the
measurement
duration time 1. Click Setting(O) from the drop
down menu.
2. Choose the duration of the measurement (in
minutes) from the Test Time drop down selection
menu. You can choose from .5 to 1440 minutes.
Measurements will cease after the allotted time has
elapsed from when the Start button is pressed.
If Continuous is selected then the measurements will
continue until the Start button is pressed again.
3. Click OK.
To view (simulate) how each measurement item works
without actually operating the DMM, the Random
Data function will input random data into DMM
Viewer to test the software functionality.
The Random Data function will be disabled if the
GDM-8255A/GDM-8251A is connected. To use the
Random Data function any instrument must be
disconnected from the operating PC or turned off.
1. Check the Random Data
checkbox
Simulate (test)
measurement
item
Now that Random Data has been checked, DMM
Viewer will function as if the multimeter is connected.
There is no need to configure any connection settings.