GW Instek GPT-9800 series User Manual - Manual (Page 12)

GLC-9000 Quick Start Guide
12
Operation  Auto/Manual/Programmable
Single fault conditions and power supply
polarity switch
 Measurement/Delay time settings
 Maximum / minimum hold
 PASS/FAIL(Upper, Lower) Judgement (limits)
 save and recall setup and measurement results
 System clock settings
 Multilanguage support
 System Self test
 EUT voltage/current/power consumption
 High output alarm and led indicators.
 Remote control interface options
Interface With the exception of the Start, Reset and power
switches, the user-interface is entirely controlled
via a touch screen.
LCD The simple, user-friendly interface is extremely
intuitive with a large 5.6” color TFT screen.
EUT Test Status The voltage, current and power consumption of
the EUT can be measured.
Built-in Voltage
Meter The built in voltage meter detects 0-300V. The
voltage meter is activated when the Safety Extra
Low Voltage (SELV) function is on.
Memory  30 sets of memory for user defined test
conditions
 50 sets of standard test conditions.
(e.g., IEC60990)
 100 sets of measurements can be saved/recalled