AMT Datasouth 4600 - Manual (Page 9)

6
LED Indicators
There are three LED indicators on the front panel, READY, MEDIA and RIBBON.
These indicators display the operation status of the printer.
READY On
– Normal operation
Off – Printer error
MEDIA On
– Normal operation
Blinking – Install new media
Printhead overheat
The printer is paused,
RIBBON On – thermal transfer mode with ribbon installed
Off – direct thermal mode ( no ribbon installed )
Blinking
– Install a new ribbon
For the FM 4602 PLUS Series, and the FM
4603 PLUS Series models, modes of thermal
transfer and direct transfer can be set via the
printer panel or Utility software.
Buttons
There are three buttons, each with two basic functions.
Button Function 1
(Press the button)
Function 2
(Press the button and
power switch together)
FEED/
CONFIG

Feed a label

Perform self test & print
configuration report
PAUSE/
CALIBR

Pause printing

Press again to resume printing

Perform a media calibration
CANCEL/
RESET

Interrupt and delete a print task

Force printer to continue after an
error is solved.

Reset FLASH settings