AMT Datasouth 4600 - Manual (Page 34)

31
Printing a Configuration Report
To perform a self-test and print a configuration report:
1. Turn off the printer.
2. Press and hold the FEED button while turning on the power.
3. When “SELF-TESTING …” is displayed on the LCD and the READY
indicator blinks, release the FEED button.
NOTE: Printers with Ethernet will take 20 second for this process, the
PAUSE button must be pressed during that period.
4. The printer prints out a configuration report.
5.
When “READY” is displayed on the LCD , the READY indicator stops
blinking but remains illuminated.
6. The following information is printed in the report:

Font list

Hardware configuration and status

Label parameters

Firmware version
Notes:
After the self-test the printer enters the diagnosis mode (Dump mode). To
continue to normal operation, press CANCEL button to cancel the diagnosis mod
(Dump mode).