AMT Datasouth 4600 - Manual (Page 67)

64
Appendix A: Printer Status
LCD display Blinking LED Description
PAUSE READY Printer is paused. Press PAUSE or CANCEL to
return to normal.
MEDIA OUT MEDIA
READY
Media is uninstalled or used up. Load new
media to the printer.
RIBBON OUT RIBBON
READY
Ribbon is uninstalled or end-of-ribbon occurred.
Load new ribbon to the printer.
SERIAL IO
ERROR READY Format or baud rate of RS232 communication is
inconsistent between printer and host.
CUTTER
FAILED READY Cutter cannot cut off the media, check media
and cutter.
MEMORY FULL READY Printer buffer full due to loaded soft fonts,
graphics or forms. Check data format. Call for
service.
HEAD OPEN READY Print head latch is not closed. To print label the
head latch must be closed.
P. SENSOR
O.R. READY Media sensor is out of range during calibration.
Make sure the media is installed and the label
sensor is under the media.
TPH TOO HOT MEDIA Printing job will start until the temperature of
TPH goes down.