AMT Datasouth 4600 - Manual (Page 48)

45
Ribbon Problems
LED/LCD Indication
READY and RIBBON LEDs Blinking
LCD Display RIBBON OUT
Possible Problems Solutions Remarks
Ribbon out Supply the ribbon roll Not applicable to direct
thermal.
Ribbon jam Recover the jam
Ribbon sensor
error Replace ribbon sensor
Note: If you use direct thermal, set with panel, Windows driver or command.
Other Problems
LED Indication
READY LED Blinking
Problems Solutions Remarks
Serial IO error Check the baud rate,
format or protocol
between host and printer Not for Centronics
Cutter failed

Check the media.

Check the connection
between cutter and
main board.

Call for service.
Memory full Check graphics and soft
fonts from host. Delete by
application software for
those no longer in use. Need to reboot the
system.
Note: After problem is solved, press CANCEL to continue printing
.