Troubleshooting, Led and lcd diagnosis, Media problems – AMT Datasouth 4600 User Manual
Page 47
44
Troubleshooting
Normally, if the printer is in not working properly, the "READY" LED blinks
continuously, and printing and communication between the host and printer
stops.
LED and LCD Diagnosis
Blinking LEDs indicate a problem. Check the LEDs and the LCD display and
refer to the following solutions:
Media Problems
LED/LCD
Indication
READY and MEDIA LEDs
Blinking
LCD Display
MEDIA OUT
Possible Problems
Solutions
Remarks
Mis-detected gap
Check the media path
Check the position of the
label sensor
For continuous media, check
application and driver, and
select continuous media.
Media out
Supply the media roll
Media not installed Install the media roll
Media jam
Recover the jam
Note: If problem continues perform a label sensor calibration.