Fire-Lite MS-9600LSC Addressable Fire Alarm Control Panel - Manual (Page 33)

MS-9600LS Series Manual — P/N 52646:B2 2/12/2010 33
Accessories Product Description
 Specifications
• Max. ANN-BUS Voltage: 28 VDC
• Max. Current:
• Alarm: 200 mA
• Standby: 35 mA
• Each LED: 10 mA
• Operating Temperature: 32 o F to 120 o F (0 o C to 49 o C)
• For indoor use in a dry location only
 ANN-I/O Connection to FACP
The ANN-I/O connects to the FACP via the ANN-BUS as illustrated in Figure 1.9. After the
ANN-I/O is connected to the panel, it must be added to the system via FACP programming. Refer
to the section titled “ANN-I/O Options” on page 123.
 ANN-I/O Module LED Wiring
There are four 12-pin connectors on the ANN-I/O module for connecting LEDs. Each set of 10
LEDs get their power from Pin 11 of the corresponding connector. Internal resistors are sized so
that there is approximately 10 mA of current for each LED. No series resistors are required. Refer
to the programming section titled “ANN-I/O Options” on page 123 of this manual.
The LEDs are wired as illustrated in Figure 1.10. Note that the illustration depicts only connectors
P1 and P2. Wiring is identical for P3 (LEDs 21-30) and P4 (LEDs 31-40).
P1 P2 P3 P4
1 10 11 20 21 30 31 40
1
2
3
4
5
TB3
JP5
TB4
JP8
TB5 TB6
TB1 + - + - + - + -
A B
Figure 1.9 ANN-I/O Connection to FACP
ANN-I/O Module
FACP
ANN-BUS and power wiring are
supervised and power-limited
96
0
0ls
to
an
ni
o.
wmf
ANN-BUS/
ACS BUS 24 VDC
nonresettable