Fire-Lite MS-4E Fire Alarm Control Panel - Manual (Page 11)

MS-2 & MS-4 Series Manual — P/N 51512:G2 10/18/2011 11
Specifications Product Description
 Zone Enable/Disable (one per zone)
• LED Indicators
 Fire Alarm (one per zone)
 Supervisory (one per zone)
 Trouble (one per zone)
 Maintenance (one per zone)
 AC Power
 NAC Disable
 Zone Disable
 NAC Fault
 System Trouble
 Power Trouble
 Walktest
 Alarm Silence
 Earth Fault LED (on circuit board) lights if zero impedance between FACP and ground exist
 Battery Fault (on circuit board)
 Charger Fault (on circuit board)
• Piezo sounder for alarm, trouble and supervisory
• 24 volt operation
• Low AC voltage sense
• Alarm Verification
• NACs Programmable for:
 Silence Inhibit
 Auto-Silence
 Strobe Synchronization
 Selective Silence (horn-strobe mute)
 Temporal or Steady Signal
 Silenceable or Nonsilenceable
• Automatic battery trickle charger
• Silent or audible walktest capabilities
• Optional NAC Class A converter module (MS-4 only)
• Optional 4XTMF Transmitter Module (MS-2 and MS-4)
• Optional 4XZMF Zone Relay Module (MS-4 only)
• Optional 4XLMF Module for RZA-4XF Remote LED Annunciator (MS-4 only)
1.2 Specifications
AC Power - TB8
MS-2/MS-4: 120 VAC, 50/60 Hz, 2.3 amps
MS-2E/MS-4E: 240 VAC, 50 Hz, 1.15 amps
Wire size: minimum #14 AWG (2.0 mm
2 ) with 600V insulation
Battery (sealed lead acid only) - J8
Maximum Charging Circuit - Normal Flat Charge: 27.6 VDC @ 0.8 amp
Maximum Charger Capacity: 18 Amp Hour battery (two 7 Amp Hour batteries can be housed in the
FACP cabinet. Larger batteries require a separate battery box such as the BB-17F.)