beautypg.com

American Water Heater VG6250T100 User Manual

Page 53

background image

53

note: If you are not qualified and licensed or certified as required

by the authority having jurisdiction to perform a given task do not

attempt to perform any of the diagnostic or service procedures

described in the following section.

If you do not understand the instructions in the following section do

not attempt to perform any procedures.

Call the technical support phone number listed on the back cover of

this manual for further technical assistance or to locate a qualified

service agent in your area.

Jumping out control circuits or components can

result in property damage, personal injury or death.

Service should only be performed by a qualified service

agent using proper test equipment.

Altering the water heater controls and/or wiring in any way

could result in permanent damage to the controls or water

heater and is not covered under the limited warranty.

Any bypass or alteration of the water

heater controls and/or wiring will result

in voiding the appliance warranty.

Altering the water heater controls and/or wiring in any way

could result in altering the ignition sequence allowing gas to

flow to the main burner before the hot surface igniter is at

ignition temperature causing delayed ignition which can

cause a fire or explosion.

mark. The water heater will continue to operate during an Alert

condition but the water heater must be serviced by a qualified

service agent as soon as possible.

resettInG control sYsteM locK outs

To reset the control system from a lock out condition; turn the power

supply off for approximately 20 seconds and then back on. Keep in

mind; if the condition that caused the Fault has not been corrected,

the control system will continue to lock out.

dIaGnostIc checKs

Turn off power to the water heater

before performing any service.

Electrical Shock Hazard

Label all wires prior to disconnecting

when performing service. Wiring errors

can cause improper and dangerous

operation.

Verify proper operation after servicing.

Failure to follow these instructions can

result in personal injury or death.

The following section, Fault And Alert Messages lists some of the

messages the control system will display on the LCD when there

are operational problems. This is not a complete list. Along with

each of the Fault and Alert messages described there will be a list

of possible causes and things to check and repair.

Only qualified service agents, as defined in Qualifications using

appropriate test equipment, should perform any service procedures

on the water heater.