Detcon 6400-N4X - Manual (Page 22)

1600/6400-N4X
1600/6400-N4X- Instruction Manual Rev. 1.1 Page 18 of 38
Figure 24 View Tag Information
5.3.7 Edit Date and Time
Edit Date and Time is used to set the current date and time. This should be checked periodically to verify that
the time is correct. Reset the time as necessary. Use the up and down arrows enter the correct date and time
and press ‘ENTER’ when complete.
Figure 25 Set Time and Date
5.3.8 4-20mA Output Setup
This menu entry is used to address Detcon AO-4 modules 4-20mA output. Use the up, down arrows to
increment, and decrement the entries. Press ‘ENTER’ after each CH# selection entry is made. Do not wait
until all entries are made before pressing the ‘ENTER’ key. The CH# entry should start at 01 and increment
up until you reach the capacity of the AO-4 modules you are connecting to (Note: there are four channels per
AO-4 module). The “Device” number must be a unique number that matches the Device ID# setting on the
front plate of the AO-4 module. The “Address” entry should increment between 1 and 4 representing the four
4-20mA outputs from each AO-4 module.
NOTE: If there are no AO-4 modules being used, do not enter any device and address information on this
screen. Miss-information entered here will cause the controller to generate a ‘No Communication Fault’.