Detcon SmartWireless CX - Manual (Page 15)

Sentinel CX
Sentinel CX Sensor Station IM Rev. 1.4 Page 11 of 26
Warning
When moving the base CX Sensor Station handle it with 2 hands securely around
the body of the unit so as to prevent a possible dropping or lifting hazard.
Warning
When wall mounting the CX Sensor Station, make sure to have 2 people working
together and follow the recommended wall mounting instruction in Section 3.1.9,
which requires suitable securement that holds four times the weight of the unit.
This will prevent chances of a dropping hazard during the installation or prevent
the risk of the unit falling off from the wall mount.
Warning
When moving or manipulating the CX Sensor Station mounted to the Tripod
Assembly, 2 people are required to work together to avoid possible lifting risk.
Do not place your fingers in the areas of the sliding tripod legs as there is risk of
hand injury. Personnel should wear safety gloves while moving and setting up the
tripod assembly.
Warning
To avoid accidental tip-over risk of injury, press and anchor the 3 pointed legs of
the tripod deep and firmly into the soft ground. If the ground is too hard for use
of the point, use an independent anchored pin and a short chain connecting to each
leg to secure the unit.
Warning
To avoid a tripping hazard, hang a brightly colored flag type marker half down
each tripod leg to provide visual warning of the location of the tripod legs.
Warning
To avoid any possible ergonomic risk in interfacing with the CX Sensor Station,
make sure it is installed at a height of 4-5 feet. Place the unit in place where it is
easy to access the front of the unit and as possible avoid placing it where there is
constant direct sunlight.