DeFelsko PosiTector 200 v.3.1 Full Manual - Manual (Page 7)

7
Probes Probes
To disconnect a probe from a body, power-down the
Gage and slide the plastic probe connector horizontally
(in the direction of the arrow) away from the body.
Reverse these steps to attach a new probe.
When powered-up the PosiTector automatically
determines what type of probe is attached and does a
self-check.
Additionally, the PosiTector accepts a number of probe types
including magnetic and eddy current coating thickness, surface
profile, environmental and ultrasonic wall thickness probes.
Perform the latest software Updates (pg. 32) to ensure probe
compatibility with your Gage. For the latest information on probe
interchangeability see www.defelsko.com/probes
PosiTector 200 probes are available for measuring a
wide variety of coating thickness applications.
B probe - 13 to 1000 microns (0.5 to 40 mils)
Ideal for polymer coatings on wood, plastic, composites, etc.
C probe - 50 to 3800 microns (2 to 150 mils)
Ideal for thicker coatings on concrete, fiberglass, etc.
D probe - 50 to 5000 microns (2 to 200 mils) -
Polyurea
- 50 to 7600 microns (2 to 300 mils) - Other Coatings
Ideal for thick or soft (attenuative) coatings
Range limits apply to polymer coatings only. NOTE: