beautypg.com

4introduction introduction, Quick start – DeFelsko PosiTector 200 v.3.1 Full Manual User Manual

Page 4

background image

4

Introduction

Introduction

PosiTector 200 Kit Contents

- PosiTector body (Standard or Advanced)
- PosiTector probe (200 B, C or D)
- Protective rubber cap for Probe
- Protective lens shield
- Wrist strap
- 3 AAA alkaline batteries
- Quick Guide instruction booklet
- Protective rubber holster
- Nylon carrying case with shoulder strap
- Belt clip for rubber holster and carrying case
- USB Cable
- 4 ounce (118 ml) bottle ultrasonic couplant
- Precision Plastic Shims
- 2500 microns (100 mils) Polystyrene Block (

C & D Probe only

)

- Certificate of Calibration traceable to NIST
- PosiSoft.net account
- Two (2) year warranty on Body and Probe

The PosiTector 200 is a hand-held Coating Thickness Gage that
uses a non-destructive ultrasonic principle to measure coating
thickness on a wide variety of substrates. It consists of a body
(Standard or Advanced) and a probe (see Probes pg. 7).

The PosiTector 200 powers-up when the center navigation button

is pressed. To preserve battery life, the Gage powers down

after approximately 5 minutes of no activity. All settings are
retained.

1. Remove the protective rubber cap from the probe.

2. Power-up Gage by pressing the center navigation button.

3. Zero the probe. (see pg. 11)

4. Adjust to a known thickness, if necessary. (see pg. 12)

5. Measure the part. (see pg. 8)

Quick Start

Quick Start