COSA Xentaur COSA 707 - Manual (Page 8)

COSA Instruments USER MANUAL COSA 707
3 Safety Information
The following safety procedures must to be followed at all times. They are a significant and essen-
tial part of this manual. Failure to follow safety procedures can result in the loss of your warranty
claims.
3.1 Safety regulations
1. The COSA 707 analyzer may only be used as indicated in this manual.
2. Our analyzers are checked according to the following regulations:
VDE 0411 (EN61010) and DIN VDE 0701 before they leave the factory.
3. Technical products are designed and manufactured according to DIN 31000/ VDE 1000 and
UVV = VBG 4 of the professional guilds for fine mechanics and electrical engineering.
4. The analyzer complies to the essential requirements of the legal regulations of the member
states of the electro-magnetic compatibility (89/336/EWG) and to the low-voltage regulations
(3/23/EWG).
3.2 Specific safety regulations
1. Use only the battery charger supplied with the analyzer for this instrument
2. No part of the analyzer, including the metal probe tube and all other metal parts & accessories
are to be used as electric conductors.
3. The analyzer is not to be used in or under water.
4. The analyzer is not to be placed near or directly exposed to open fire or heat.
5. The specified probe temperature range is not to be exceeded, as the probe, temperature sen-
sory mechanism and sensor could be damaged or destroyed.
6. The analyzer shall void dropping.
7. Caution: Moisture, being pumped out of the condensates trap can be slightly
acidic.
In case of skin contact IMMEDIATELY: clean affected parts of the body.
Avoid getting liquid in eyes.
Please carefully clean all parts that come into contact with the condensates.
8. After measurement, vent the analyzer with ambient air and allow the probe to
cool. A hot probe could cause burns or ignite flammable material.
9. The fumes from certain materials (for. example, cleaners, petrol, spirit, varnish)
may damage the sensors of the analyzer. Do not store or use these or other simi-
lar fluids near the analyzer.