COSA Xentaur COSA 707 - Manual (Page 29)

COSA Instruments USER MANUAL COSA 707
www.cosaxentaur.com 29
11.8 Power ON and zeroing
Press the ON key. The analyzer will start zeroing without any further action from the user.
The probe shall NOT be installed in the stack during zeroing!
While the analyzer is zeroing you will see a blinking
symbol in the task bar indicating the
progress of zeroing.
Once the zeroing cycle is finished the analyzer is ready for measurement.
If any defective sensors will be detected during the zeroing cycle you will get an error message on
the display.
Repeating the zeroing
The zeroing can be repeated at any time as long as the probe is not inside the stack. In the main
menu you select “Zeroing”, and after the displayed message press the OK key.
OK
, Zeroing
OK Start zeroing