Triton ARGO User Manual - Manual (Page 73)

C4
A PPENDIX C
Programmable Features
The locks are initially set with the standard feature of a single 6-digit code.
Based on your requirements, additional features may be added in the lock BUT THEY MUST BE
PRE-PROGRAMMED by Triton prior to shipment of the unit.
- Time Delay Override :
Ability to add second combination to override delay period
- Disable Lock (Optional alarm box required):
Input signal disables opening of lock by valid code
Programmable Feature(s) descriptions:
Add User (If Manager, Time Delay Override, Remote Override, or Dual Combination feature programmed)
Always perform this operation with the door open
1. Enter Manager Code and HOLD DOWN LAST DIGIT OF CODE until the lock signals with two (2)
sets of double beeps.
2. PRESS 1. Lock signals twice. Lock will only signal twice if the User code is not already in use.
It will beep once if a User is already installed and three (3) times if the function has not been
programmed in the lock.
3. Enter User code twice. The lock signals twice after each valid entry.
4. If a mistake is made, wait thirty (30) seconds and repeat steps 1 - 3.
Valid Code Entry - Double signal after valid six (6) digit code is entered.
Invalid Code Entry - Triple signal and old code is still valid.
Disable User (Manager feature only)
Always perform this operation with the door open
1. Enter Manager Code and HOLD DOWN LAST DIGIT OF CODE until the lock signals with two (2)
sets of double beeps.
2. PRESS 2. Lock signals once. User is now temporarily disabled.
3. If a mistake is made, wait thirty (30) seconds and repeat steps 1- 2.
- Manager (Factory set to 1-2-3-4-5-6):
Add/remove second user
Enable/disable second user
- Dual Code:
Two (2) combinations required to open.
- Silent Signal Alarm (Optional alarm box required):
Duress signal if last number of code(s) is entered using one (1) number higher or one (1) number lower.
Time Delay:
Delay period 1-99 minutes.
Open period 1-19 minutes