Triton ARGO User Manual - Manual (Page 30)

26
ARGO U
SER
M
ANUAL
1. Move the packer plate to the rear of the cassette (toward the handle).
Note: The packer plate action will depend on the type of cassette in use. Some cassettes require you
to maintain pressure on the packer plate as needed while loading notes. Other cassettes use a locking
mechanism to hold the packer plate in the loading position. On these cassettes, pull the packer plate all
the way back to the handle end of the cassette and turn the key to latch the packer plate into the loading
position.
2. Count the number of bills that remain in the cassette, if any. Next, count the number of bills that are being
added into the cassette.
3. Add the number of bills being placed into the cassette to the number that remained. The total number of
these bills will be entered in the Enter Cassette Quantity option (shown in step 6 of C ASSETTE C LOSE
P
ROCEDURES
).
4. Make sure the note pile is as even as possible. If
necessary, use your hands to smooth and level the pile.
5. On cassettes that do not use a packer plate locking
mechanism, release the packer plate against the notes.
If the cassette uses packer plate locking, turn the
key to release the catch, allowing the packer plate to
compress the notes.
6. Close and lock the cassette. Remove the key. Slide the
cassette back into its compartment in the dispenser.
Make sure the cassette is fully inserted! You will feel
the cassette latch securely into the snap catches.
7. Perform the removal and loading steps for the other cassette.
Pull the packer back. Some
cassettes allow the packer-plate
to be latched in position using
the key-lock. (Insert)
Load notes.
Removing the Reject Cassette
The reject tray is located just above the currency cassette in the dispensing
mechanism. Follow these steps to remove the reject tray:
1. Slide the reject tray out of its compartment in the dispensing mechanism.
Place the tray on a fl at surface.