Triton ARGO User Manual User Manual
Page 39
35
ARGO U
SER
M
ANUAL
4. Remove the pape r and spool from the paper bracket.
5.
Remove the tab securing the end of the new paper roll
to itself. Use scissors to cut off all of the paper up to
and including the glue tab.
6. Remove the plastic spindle from the old paper roll and insert into the new roll of paper. Use a new roll
of 60mm wide (or 80mm wide) thermal paper as appropriate for the printer.
Be sure the spindle is inserted so that the paper will feed from the TOP of the roll when it is installed on
the paper bracket.
7.
Place the new roll back on the paper bracket by sliding
the small, slotted end of the spindle onto the slot in the
bracket as shown. Note that the paper feeds from the
TOP of the roll!
8.
Feed the end of the paper into the printer take-up slot.
The printer will activate and automatically feed the
paper through the printer and slightly out the front of
the control panel.
9. If the printer does not feed automatically, open the
printer assembly by pulling the release pin on the side.
Remove paper roll from bracket.
Place paper roll on bracket. Paper feeds from top of roll!
Feed paper into the printer take-up slot.
Pull release pin