Spectra Precision Survey Pro v3.80 Ranger GPS User Manual - Manual (Page 87)

Trouble Shooting
83
•
Go to Rover Setup. Set the rover
4. Check point
•
Go to Control Points and select point 3 for a
&KHFN. The
results should be near perfect.
5. Feature Collection
•
From the Survey Menu, tap 'DWD &ROOHFWLRQ
•
Tap )HDWXUH, choose
Continuous by Time and enter a small
interval ( 0.1 min). Before tapping 6WDUW, hot key to the auto
line work (Ctrl. L) and add the description for this feature to
the line work. This will draw a line in real time as points
with this description are collected.
•
Tap
6WDUW to open the Occupy Data Points screen. Tap $FFHSW
to start the continuous data collection.
•
Allow this to run for a minute to collect a number of points.
Tap View Points to see how many points you have stored so
far. Tap
'RQH when you are finished.
Note: Notice points from continuous collection are connected with a
line on the Map tab.
One Point Localization
Objectives
This tutorial job will teach you:
•
How to start a new job with one point and begin measuring ground
level distances without any existing control.
Scenario
You show up at a new job site where no previous coordinates exist.
You want to use RTK to create a new ground level coordinate system
for a legal and topo survey.