Spectra Precision Survey Pro v3.80 Ranger GPS User Manual User Manual
Page 37
RTK Data Collection
33
base setup. You then SET this reference position in the GPS
receiver and configure the base coordinate in Survey Pro.
Note: It is strongly recommended that you use only one autonomous
GPS base position in a job. If you must use multiple autonomous
setups in a single job, you will be prompted to setup and select a
separate site record for each setup group.
4.
Tap
1H[W.
Set the Base
The final step of the Base Setup wizard will depend on the base point
chosen. If the base (lat, lng, ht) is known or can be computed, the
final step is to SET the base at the known geodetic position. If the
base (lat, lng, ht) is not known, the final step is to GET an
autonomous position to SET the base with.