Spectra Precision Survey Pro v3.80 Ranger GPS User Manual - Manual (Page 77)

73
Post Processing Data
Collection
Post processing data collection uses GPS raw data stored in the
receiver’s internal memory. Raw data from multiple receivers is
combined and then PC software is used to process the base line
measurements. The following section describes how to start
recording raw data in the receiver internal memory for both post
processing only data collection and simultaneous RTK and post
processing data collection.
Field Procedure
Turn On Post Processing
1. Go to Settings from the Job menu.
2. On the Post Process card, specify a non-zero recording
interval.
Note: For simultaneous RTK and post processing data collection,
this is all you need to do. Receiver recording will be started
automatically when you configure the RTK base and rover. Data
collection sessions will be completed automatically when you occupy
an RTK point. If you wish to do post processing only data collection,
you need to complete the next step before tapping OK.
3. On the Receiver card, select the correct GPS Mode . If you
want to use simultaneous RTK plus post processing data
collection, select
RTK mode. If you want to do post processing
only data collection, either static or stop and go, set the GPS
Mode to Post Process .
4. Tap 2..