Spectra Precision Survey Pro v3.80 Ranger GPS User Manual - Manual (Page 86)

GPS User’s Manual
82
Reuse Localization Solutions
Objectives
This tutorial job will teach you:
•
How to reuse a localization solution in a new job.
•
How to select a Localization adjustment record from the
coordinate system database.
•
How to use a control file.
Scenario
You want to return to the project site from the first tutorial to add
some new measurements. You want to use a new job file for this new
work, but you do not want to collect the control measurements again.
Procedure
1. Create a new job.
•
Choose 1001 as the first point. Do not choose a point that
already exists in the control file, since we can not load the
control file if there are common point names in both jobs.
•
Go to the Files card from the Job, Settings screen. And select
TDSControl_Ground.job as the control file
2. Set the projection.
•
From the Survey Menu, tap 3URMHFWLRQ. On the Horizontal
card, tap 3URMHFWLRQ 6HWXS.
•
Tap 3LFN IURP 'DWDEDVH to open the Localization Data Base
selection screen.
•
In the Data Base box, select View Sites . From the Site control,
pick the name you gave to the Localization site in the first
tutorial.
•
Tap 2.. The Localization solution is now set.
3. Set up base and rover.
•
Put the base station on point CHAP (or any other GPS
measured points from the control file) and SET the base.