LumaSense Technologies MCS640 Manual - Manual (Page 5)

1
1
Section
General Information
1.1 Warranty
LumaSense Technologies, Inc., will repair or replace any parts or material found
defective which are due to flaws in design or manufacture when reported in writing
within one year from the date of sale (unless another term is agreed to in writing by
LumaSense as part of the sale). Once a return authorization is approved and assigned,
instruments to be repaired under this warranty are to be returned to LumaSense, shipping
charges prepaid by the user who assumes all risk and cost of shipping to and from the
plant.
In the event that LumaSense, in its sole judgment and discretion, determines, for
purpose of repair, that an on-site inspection is required, this warranty does not cover
transportation of factory-trained service personnel to and from the installation site or
expenses while there.
This warranty is void if the instrument is disassembled, tampered with, altered or
otherwise damaged, without prior written consent from LumaSense, or if considered by
LumaSesne to be abused or used in abnormal conditions.
This warranty shall constitute the exclusive remedy available to the user and shall be
considered a condition of sale and use.
The manufacturer, LumaSense Technologies, Inc., shall not be liable for any loss, or
damage, including loss of profit or consequential damages resulting from, or attributed to,
the use of its product or resulting from a defect in design or manufacture of the product.
The user shall determine the particular use to which the product shall be applied and the
seller excludes and disclaims any warranty that the product is fit for such use.
1.2 Safety Notations
The following notations appear before instructions intended to avoid injury to personnel
or damage to equipment.
This may cause injury to personnel or damage to user’s
equipment.
This may cause damage to the product.
1.3 Operator Training
To best understand and utilize the measurements and images derived from the
operation of this instrument, the operator should understand the basics of heat transfer
and infrared radiation theory. Notes on these basics can be found in Section 4 of this
manual. Education and training in these subjects should be provided by qualified
personnel.
The MCS640 instrument
is a sealed unit. Do not
attempt to open the
instrument housing
as this will void the
warranty. Please refer to
the warranty statement
found in Section 1.1 of
this manual.