LumaSense Technologies MCS640 Manual - Manual (Page 12)

8
Section 3 Getting Started
3.1.2 Connecting the Camera to a Network
Device
Connecting the MCs640 to a Computer using a straight Cable
1. Connect one end of an RJ45 (Ethernet) cable to the Ethernet port on the camera
and the other end to the switch.
2. Connect one end of an RJ45 (Ethernet) cable to your computer and the other end
to the switch.
3. The MCS640 requires a Gigabit Ethernet network adapter (see the software
manual for a list of supported adapters). All cabling should be Cat5e or Cat 6.
4. Connect camera power supply to the camera.
5. Turn on the computer.
6. Consult the software manual for setup and configuration instructions necessary to
make the system operational.
3.2 Installing the Software
If your system was delivered with MikroSpec R/T thermal imaging software, then you
have available all the necessary executables and support files needed for remote camera
control operations. However, you must first install the software and allow your PC to
reboot before using the camera control features of the R/T software.
Note: Do not install the software from a standard Windows™ Administrator account.
Instead, use an account with full Administrator rights. Consult your Windows™ user
manual or contact your IT department for more information on how to assign the proper
permissions.
To install the MikroSpec R/T software, perform the following procedures:
1. Close all programs on your PC
2. Insert the MikroSpec R/T CD in your CD-ROM Drive
3. Follow the on-screen commands to complete the installation.