Elitegroup A929 (V2.0) User Manual
Page 5

Notices
Federal Communications Commission Radio Frequency
Interference Statement
NOTE:
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate
radio frequency energy and if not installed and used in
accordance with the instruction manual may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the
following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
•
Consult the dealer or an experienced radio TV technician for help.
Notice:
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment. Shielded interface cables and a non-shielded AC power cord
must be used in order to comply with emission limits. This equipment is
to be used with power supply: Rated input 100-240 Vac, 50-60 or 47-
63Hz, 2.0A maximum; output 19 Vdc, 4.7A min., 90W min. There is no
internal power supply.
v