Brocade Mobility 1220 Access Point Installation Guide User Manual
Page 22
External antenna model suspended ceiling t-bar mount
2
Brocade Mobility 1220 Access Point Installation Guide
17
53-1002916-01
External antenna model suspended ceiling t-bar
mount
Ceiling mount requires holding the Mobility 1220 Access Point up against a T-bar of
a suspended ceiling grid and twisting the case onto the T-bar. If deploying an
external antenna model Mobility 1220 Access Point on a ceiling T-Bar, access point
mounting kit (Part No. KT-135628-01) or ceiling mount hardware (SCT-2) is
required.
Suspended ceiling t-bar mount procedure - using mounting
kit
The following installation uses the access point mounting kit (Part No.
KT-135628-01) to deploy the access point on a ceiling T-Bar.
1. If required, install and attach a Kensington security cable (customer provided)
to the unit’s lock port.
2. Using only the mounting bracket from the mounting kit, rotate and click the
mounting bracket into the mounting slots on the Mobility 1220 Access Point.
3. Attach an Ethernet cable from the access point to a device with an 802.3af
compatible power source or use the PWRS-14000-148R power supply to supply
power to the Mobility 1220 Access Point (once fully cabled).
4. With the ceiling tile raised, slip the T-Bar bracket on to the exposed T-Bar
flange.
5. Lower the ceiling tile and verify the stability of the T-Bar mounting bracket
connection. There will be no stability in this assembly until the ceiling tile is
lowered on to the T-Bar to secure the mounting hardware.
6. Verify the unit has power by observing the LEDs.
CAUTION
If not using an 802.3af capable device to power the Mobility 1220
Access Point, ensure only the Mobility 1220 Access Point’s designated
power supply (PWRS-14000-148R) is used to supply power to the
access point. Using an incorrectly rated power supply could damage